All times are UTC + 10 hours [ DST ]




Post new topic Reply to topic  [ 3 posts ] 
Author Message
 Post subject: Apex seals
PostPosted: Mon Jun 19, 2017 7:20 am 
Offline
Boost Me Up
User avatar

Joined: Mon Apr 27, 2009 7:03 am
Posts: 742
Location: west auckland NZ
I should know the answer to this, but am doubting myself......

When running a fullcut bridgeport, (Primary/secondary) do you have to run single piece apex seals like carbons? or can the two piece still be used with no fear of the corner piece falling out?

12a if that makes a difference.


Top
 Profile E-mail  
 
 Post subject: Re: Apex seals
PostPosted: Mon Jun 19, 2017 6:16 pm 
Offline
Rotor Junkie
User avatar

Joined: Sat Dec 04, 2004 11:16 am
Posts: 5550
Location: Geelong
It really depends on the ports.

I run two piece seals in my full cut bridgies without issue. Big eyebrow, chamfered housing type port. Basically what Xtreme Rotaries do.

_________________
Don't click here


Top
 Profile  
 
 Post subject: Re: Apex seals
PostPosted: Mon Jun 19, 2017 7:54 pm 
Offline
Boost Me Up
User avatar

Joined: Mon Apr 27, 2009 7:03 am
Posts: 742
Location: west auckland NZ
Thanks, yes was thinking id try to keep the eyebrow to a reasonable width for extra support.
Think ill just use the 2 peice steels then cheers


Top
 Profile E-mail  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 3 posts ] 

All times are UTC + 10 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 13 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group