Hey guys just want to know if I can still get a new loom for my mtx8 ecu.... Or what I need to do as I have lost the crank angle sense plug and the normal loom is a bit old

Cheers

i have made my own before ( for a digi2 pro,, but very much the same beside the cas plug itself )
you need the 20 pin socket from an ATX power pack ( from an old PC ) and a couple of lengths of 10a trailer wire , and a couple of lengths of 25A red and black wire

for the CAS i pick up some shielded microphone coax ( with 4 wires inside ) and make it extra long to take a route well away from alt and coils and fan
and bridge the shield at the ecu plug end to the black earth wire plug socket

i only need the cas plug to the ecu

why not try microtech !!!

http://microtechefi.com/index.php?route ... duct_id=89

"Replacement wiring looms are available to suit the entire range of MicroTech Engine Management ECU's from the MT series onwards. All MicroTech wiring looms come complete with wiring diagram, fuel pump relay, fuse holder & vacuum hose. Each wire in the MicroTech loom is individually labelled to make installation as simple & straightforward as possible. "

they don't come with plugs though - contact Australian Fuel Injecion as they carry plugs to suit all applications.